POLTE configuration in mangOH RED

Getting error message while configuring POLTE in the mangOH RED with HL7800/HL7800M chip installed.

AT%SETACFG=“locsrv.operation.locsrv_enable”,“true”
ERROR
%SETACFG=“polte.config.enable”,“true”
ERROR
AT%SETCFG=“polte.config.server_url”,“mqtt.polte.io
ERROR
AT%SETACFG=“modem_apps.Mode.AutoConnectMode”,“false”
ERROR

Using HL7800 with latest firmware “HL7800.4.6.8.0”.Kindly share your feedback regarding the same.

you should use AT+GNSSCONF.
you can download the latest AT command guide for HL78 module.

https://source.sierrawireless.com/resources/airprime/software/airprime_hl78xx_at_commands_interface_guide/#sthash.87HaLSxs.pKEjXndk.dpbs

I am using AT+GNSSCONF command as well as the POLTE commands. I think it is related to the new firmware. I update the firmware to latest(HL7800 FW from Sierra Wireless), But bootloader COM port is not responding after some initial messagesbootloader .

You need to enter this in uart1
At+switracemode=RnD

Yes,I got that command from Sierra.Now bootloader is working but AT+SWITRACEMODE=Customer command giving error message.

Why are you switching the mode? What do you want to do?

It is the steps mentioned in the POLTE setup and user guide document.

which user guide document?
Can you attach here?

“AT+SWITRACEMODE=Customer” changed with “AT+SWITRACEMODE=CUSTOMER” and its worked.POLTE function configured and location data getting on my device.
Thanks for your time and support.