How to build MCP2515 CANBus drivers for mangOH

have you checked my document?
You might have a look on the file

I found the file sh, but this is the result:

you need to chmod 777

Yes, I followed the guide, but this is the result:

why there is a space inbetween

Sorry, but without space I obtain an error line:


I don’t see problem, maybe you can diff the script here: (1.8 KB)

root@swi-mdm9x28-wp:~# chmod 777 /tmp/
root@swi-mdm9x28-wp:~# /tmp/
“/tmp/ board [slot]” where board is “green” or “red” and slot is “0” or “1”

It works but now:

you need to compile the mangoh layer
do you have the driver (can_iot.ko) in your platform?

Sorry, for mangoh layer do you need the steps followed in the guide below?,-9x15-based-systems.

I don’t know, especially not sure if the patch is needed.
For my testing, i did not follow that guide, but i can see can0 interface

where i can find the driver (.ko) for wp76?

you can use the document above to download the mangoh image to your module or you can compile the mangoh source which already provided inside the document.

Sorry, I’m following your guide, but I’m blocked at the third step of the mangOH image building:

Where can I find the folder WP76_R13_Components? I downloaded from legato website:

but I obstained a file .spk in download:

You can find in here

I just tried but there are only spk or cwe files :woozy_face:

Isn’t there Base Legato System

are you referring to this?

then you can download the source here:

I’m so sorry, but I’m continuing to remain blocked at the same point. How can I do to have the folder WP76_R13_Components in my Downloads? In the webpage that you send to me I cannot find any folder at exception of Legato-Dist-Source-mdm9x28-SWI9X07Y_02.28.03.01.tar.bz2 :pensive: