Green hangs going into firmware download mode


#1

so i have had no issues reflashing a device until this morning… seems its just hanging.

swiflash -m “WP85XX” -i custom-firmware.spk
Detecting USB of the target
DONE
Communicating with the target
DONE
Switching to firmware download mode

swi-mdm9x15 login: [ 29.750526] mbim_open: USB cable not connected
[ 29.755959] mbim_open: Exit, mbim file opened
[ 29.764932] mbim_read: Requests list is empty. Wait.
[ 33.848344] i2c i2c-0: Added multiplexed i2c bus 1
[ 33.868304] i2c i2c-0: Added multiplexed i2c bus 2
[ 33.908347] i2c i2c-0: Added multiplexed i2c bus 3
[ 33.928338] i2c i2c-0: Added multiplexed i2c bus 4
[ 33.968289] i2c i2c-0: Added multiplexed i2c bus 5
[ 33.997436] i2c i2c-0: Added multiplexed i2c bus 6
[ 34.017305] i2c i2c-0: Added multiplexed i2c bus 7
[ 34.036471] i2c i2c-0: Added multiplexed i2c bus 8
[ 34.040470] pca954x 0-0071: registered 8 multiplexed busses for I2C switch pca9548
[ 34.067022] input: ST LSM6DS3 Accelerometer Sensor as /devices/i2c-0/0-006a/input/input1
[ 34.134991] input: ST LSM6DS3 Gyroscope Sensor as /devices/i2c-0/0-006a/input/input2
[ 34.160903] input: ST LSM6DS3 Significant Motion Sensor as /devices/i2c-0/0-006a/input/input3
[ 34.196459] input: ST LSM6DS3 Step Counter Sensor as /devices/i2c-0/0-006a/input/input4
[ 34.265985] input: ST LSM6DS3 Step Detector Sensor as /devices/i2c-0/0-006a/input/input5
[ 34.312833] input: ST LSM6DS3 Tilt Sensor as /devices/i2c-0/0-006a/input/input6
[ 34.369174] lsm6ds3 0-006a: lsm6ds3: probed
[ 40.229940] gpio_sync_ri: RI owner is Modem
[ 47.446940] softdog: Software Watchdog Timer: 0.08 initialized. soft_noboot=0 soft_margin=60 sec soft_panic=0 (nowayout=0)
[ 3332.456584] msm_otg msm_otg: Avail curr from USB = 2
[ 3332.460582] ci_hdrc ci_hdrc.0: CI_HDRC_CONTROLLER_SUSPEND_EVENT received
[ 3332.948206] msm_otg msm_otg: USB in low power mode
[ 3334.358858] msm_otg msm_otg: USB exited from low power mode
[ 3334.363436] ci_hdrc ci_hdrc.0: CI_HDRC_CONTROLLER_RESUME_EVENT received
[ 3334.370089] msm_otg msm_otg: Avail curr from USB = 500
[ 3334.375919] android_disconnect: android_disconnect: Disconnected
[ 3334.386601] sps:REVISION of BAM 0xd03c8000 is 0x5.
[ 3334.420967] android_work: android_work: sent uevent USB_STATE=DISCONNECTED
[ 3334.478040] android_setup: android_setup: Connected
[ 3334.482892] android_work: android_work: sent uevent USB_STATE=CONNECTED
[ 3334.488630] android_disconnect: android_disconnect: Disconnected
[ 3334.509201] android_work: android_work: sent uevent USB_STATE=DISCONNECTED
[ 3334.626064] android_setup: android_setup: Connected
[ 3334.631405] android_work: android_work: sent uevent USB_STATE=CONNECTED
[ 3334.637051] android_usb gadget: high-speed config #1: android_usb
[ 3334.643216] android_setup: android_setup: Configured
[ 3334.657805] gsmd_connect_work: unable to open smd port:DS err:-19
[ 3334.748542] android_work: android_work: sent uevent USB_STATE=CONFIGURED
[ 3349.425423] nmea: smd opened
rcK: Executing run_K_scripts…
Stopping linkmon: stopped linkmon (pid 727)
done
*** Simple RIL / QMI test console v2.0 ***
*** starting console ***
Type in simple RIL commands and observe feedback
Use ‘quit’ command to terminate simple RIL
Stopping mbimd: [SIMPLE_RIL_INTEGRITY]
simple ril init complete
[SIMPLE_RIL_INTEGRITY]
simple ril NW reg init complete
stopped restart_mbimd (pid 711)
[ 4187.684327] mbim_read: Waiting failed
[ 4187.688569] mbim_release: Close mbim filestopped mbimd (pid 734)
done
Legato shutdown sequence
ERROR (UNSPECIFIED)
Stopping Legato…[NOTIFICATION]
…[NOTIFICATION]
NW_REG (NO SERVICE)

[ 4210.820387] mangoh green mangoh green: In the remove
[ 4211.119761] lsm6ds3 0-006a: lsm6ds3: removed
.
DONE.
Finished Legato stop Sequence
Stopping QCMAP_ConnectionManager: no QCMAP_ConnectionManager found; none killed
Stopping netmgrd: stopped netmgrd (pid 575)
done
Stopping adbd: [ 4213.627223] adb_release
stopped adbd (pid 694)
done
Stopping qmuxd: done
[ 4213.931115] ch_notify on a closed smd_pkt_dev_msm id:0
[ 4214.008209] ch_notify on a closed smd_pkt_dev_msm id:1
[ 4214.080695] ch_notify on a closed smd_pkt_dev_msm id:2
[ 4214.141583] ch_notify on a closed smd_pkt_dev_msm id:3
[ 4214.200915] ch_notify on a closed smd_pkt_dev_msm id:4
[ 4214.260704] ch_notify on a closed smd_pkt_dev_msm id:5
Stopping diagrebootapp: stopped diagrebootapp (pid 411)
done
[ 4214.360689] ch_notify on a closed smd_pkt_dev_msm id:6
stopping DNS forwarder and DHCP server: dnsmasq… stopped /usr/bin/dnsmasq (pid 723)
done.
[ 4214.420692] ch_notify on a closed smd_pkt_dev_msm id:7
Deconfiguring network interfaces… no ntpd found; none killed
[ 4214.796428] smsc95xx 1-1.3.1:1.0 eth0: hardware isn’t capable of remote wakeup
done.
Stopping qti: stopped qti (pid 378)
done
Stopping syslogd/klogd: stopped syslogd (pid 394)
stopped klogd (pid 399)
done
Stopping Dropbear SSH server: stopped /usr/sbin/dropbear (pid 682)
dropbear.
stopping time daemon
Stopping time_services: stopped time_daemon (pid 253)
done
stopping ntpd
no ntpd found; none killed
K96mount_unionfs: RO rootfs will be fudged.
K98mount_early: Executing mount_early_user_stop…
sh: /mnt/flash: unknown operand
K98mount_early: Executing mount_early_legato_stop…
sh: on: unknown operand
K98mount_early: Executing mount_early_userrw_stop…
rcK: Executing kill_all_proc…
rcK: Executing umount_fs_generic…
rcK: Executing print_shutdown_msg…
** SYSTEM SHUTDOWN COMPLETE **
The system is going down NOW!
Sent SIGTERM to all processes
[ 4216.214344] UBIFS (ubi2:0): un-mount UBI device 2
[ 4216.221668] UBIFS (ubi2:0): background thread “ubifs_bgt2_0” stops
Sent SIGKILL to all processes
Requesting system reboot
[ 4218.253806] reboot: Restarting system
[ 4218.256462] Going down for rest